When the diamond segment is welded to the blank blade, try to sample some segments and compare the size, weight and other parameters of the sampled segments If there is any problem, find the manufacturer for quality treatment in time

During the cutting process of diamond segments, various problems will be encountered Among them, the low sharpness of the segment is the most common problem encountered in daily use How to solve the situation that the diamond segment speed is not fast enough? This article will give a detailed introduction and explanation

The silver copper and copper-phosphorus components are common materials for welding the segments on the saw blade substrate, but there are some subtle differences This article introduces these differences to let everyone better understand the technology and craftsmanship of diamond segment welding

The porosity of the diamond segment is actually more accurate, the volume of the diamond segment particles divided by the stacking volume, So does the void ratio have any meaning? This article will provide related explanations

The production process of diamond segment is relatively simple, the processing machinery is also relatively cheap, and the raw materials are also easy to buy Therefore, since the 1990s in the world, processing plants with small diamond segments factories have been established, In this early era when the craftsmanship was not developed, these small factories held a group for warmth, In Fujian, Jiangxi, Hubei, Shandong and other regions, some small tool bit processing factories have appeared one after another This article mainly discusses the advantages and disadvantages of these small diamond segment factories

The production process of diamond segment is not complicated, nothing more than mixing, cold pressing, sintering and other steps At present, all countries with an initial industrialization system can produce However, due to the raw materials and the conditions of each country, there are not many countries that can mass produce diamond segments Most countries still adopt the method of importing diamond segments

The compactness of a diamond segment is a very important parameter of a diamond segments The more dense the diamond segments, the cutting efficiency and life will increase correspondingly

In the process of cutting stone with diamond segment, various problems often appear, Among them, the segment is not wear-resistant and the life is short is an extremely common problem So why does the segment wear too fast? How to deal with and solve it? This is the question that this article should discuss

According to the bond material, diamond segment are divided into iron-bond segment, copper-bond segment, cobalt-bond segment and tungsten carbide-bond segment Among them, iron-bond segment are the most common type of segments, according to their iron content The ratio of powder is divided into low-iron-bond segment and high content-iron bond segment, so what are the uses of high content-iron bond segment?

The diamond segment has undergone two molding processes from powder to solid alloy agglomerates, the first is cold pressing and the second is hot pressing and sintering

The diamond segment is made of the combination of diamond and bond binder So what are the specific components of the bond binder?

Diamond segment is a diamond tool used to cut hard materials such as stone, concrete, asphalt, ceramic tiles, etc , especially when facing materials with a large hardness span-stone, it is often have the problem of can’t cut, then why does this happen?