The production process of diamond segment is relatively simple, the processing machinery is also relatively cheap, and the raw materials are also easy to buy Therefore, since the 1990s in the world, processing plants with small diamond segments factories have been established, In this early era when the craftsmanship was not developed, these small factories held a group for warmth, In Fujian, Jiangxi, Hubei, Shandong and other regions, some small tool bit processing factories have appeared one after another This article mainly discusses the advantages and disadvantages of these small diamond segment factories

The production process of diamond segment is not complicated, nothing more than mixing, cold pressing, sintering and other steps At present, all countries with an initial industrialization system can produce However, due to the raw materials and the conditions of each country, there are not many countries that can mass produce diamond segments Most countries still adopt the method of importing diamond segments

The compactness of a diamond segment is a very important parameter of a diamond segments The more dense the diamond segments, the cutting efficiency and life will increase correspondingly

In the process of cutting stone with diamond segment, various problems often appear, Among them, the segment is not wear-resistant and the life is short is an extremely common problem So why does the segment wear too fast? How to deal with and solve it? This is the question that this article should discuss

According to the bond material, diamond segment are divided into iron-bond segment, copper-bond segment, cobalt-bond segment and tungsten carbide-bond segment Among them, iron-bond segment are the most common type of segments, according to their iron content The ratio of powder is divided into low-iron-bond segment and high content-iron bond segment, so what are the uses of high content-iron bond segment?

The diamond segment has undergone two molding processes from powder to solid alloy agglomerates, the first is cold pressing and the second is hot pressing and sintering

The diamond segment is made of the combination of diamond and bond binder So what are the specific components of the bond binder?

Diamond segment is a diamond tool used to cut hard materials such as stone, concrete, asphalt, ceramic tiles, etc , especially when facing materials with a large hardness span-stone, it is often have the problem of can’t cut, then why does this happen?

The sharpness of a diamond segment is a criterion for judging whether a segment is good or bad Through the sharpness of the diamond segment, Therefore, it is the most basic common sense to judge the cutting efficiency of the diamond segment, So where does the sharpness of the diamond segment reflect? What effect does the segments with low sharpness have on cutting? This article will answer them one by one

The sintered diamond segment often has many problems, such as falling, fracture, partial wear, etc In such a situation, how to repair the cutter head is very important This article introduces dozens of the most common problems, so that everyone knows and understands the problems of sintered diamond segments and how to repair them

Black granite is a kind of stone that people often encounter in life The common black stone is mostly produced in China, such as Shanxi black, Fengzhen black, Hebei black and other stones in China, of course, there is also a kind of black granite stone that is more common in India-Black Galaxy Granite These stones are very common, and the segment used to cut these stones is worthy of our discussion and research

This article mainly introduces the diamond in the marble segment, which is used to distinguish the difference between the granite segment and the sandstone segment through the content and grade of diamond